1:
2:
3:
4:
5:
6:
7:
8:
9:
10:
11:
12:
13:
14:
15:
16:
17:
18:
19:
20:
21:
22:
23:
24:
25:
26:
27:
28:
29:
30:
31:
32:
33:
34:
35:
36:
37:
38:
39:
40:
41:
42:
43:
44:
45:

//Message Center - PUB mode only
set mc_enable 1
//Turns on/off the Message Center engine. [1 = on. 0 = off]

set mc_maxmessages 1
//Maximum number of your LAST message. If this is 99 then your LAST message dvar would be mc_message99. It is best to keep this as low as necessary for performance purposes. For example, mc_maxmessages 5 would check the following dvars for messages: ms_message1, mc_message2, mc_message3, mc_message4, and mc_message5.

set mc_delay 90
//Sets the generic delay in seconds between messages being displayed. This delay is used if a message-specific delay is not specified.

set mc_messagedelay 90
//This is the message-specific delay in seconds for the message specified by [#] in the dvar. For example, mc_messagedelay5 would set the message delay between mc_message5 and whatever message comes before it.

//SPECIAL MESSAGE FUNCTIONS:
//There are a couple special message functions built in:
//<*nextmap*> & <*gtrules*>
//Usage: Set any message dvar to exactly the special function. For example:
set mc_message1 "<*nextmap*>"

//<*nextmap*> will show the next map and gametype
//<*gtrules*> will show the rules for the current gametype

//The gametype rules must be specifed by the admin via
//specific dvars listed below:

set mc_rules_sd
set mc_rules_ctf
set mc_rules_tdm
set mc_rules_dm
set mc_rules_hq
//These dvars are used in conjuction with the <*gtrules*> special value for a Dvar message. It specifies the message to display for the current gametype. For example, mc_rules_sd could be set to "^3S&D Rules: ^5First team to 7 wins" if that is your rules for the S&D gametype.


//Welcome Center - PUB mode only
set wc_enable 1
//Turns the Welcome Center engine on/off. The welcome center will display up to 5 lines of text after the player spawns into a map for the first time. This a great place to welcome players and remind them of any important rules. [1 = on. 0 = off]

set wc_line1 "HuHU"
set wc_line2
set wc_line3
set wc_line4
set wc_line5
//These dvars set the text to be used on each line of the Welcome Message.